Positioning guide for Atomstack S10 Pro and Sculpfun honeycomb cutting mat (400x400)
Use this to position your honeycomb cutting mat to the real (0;0) point with Atomstack S10 Pro laser-engraver/cutter
17
199
1
1461
actualizado 10 de diciembre de 2022
Descripción
PDFJust a remix to use a 400x400 honeycomb cutting board from Sculpfun with the Atomstack S10 Pro to position your material at the real origo point. Had to edit the offset to fit the frame of the honeycomb. Now it is snap-fit to the honeycomb AND the left front leg of the cutter. Only thing you have to adjust manually is the far end Y-axis offset.
Leave a comment if you have any suggestions, or just like it.
Etiquetas
Origen del modelo
El autor ha hecho un remix de este modelo.
