Virpil WarBRD base to Thrustmaster Warthog mount adapter

I needed a way to mount a Virpil WarBRD base to my Obutto R3volution which has stick mounts for Thrustmaster Warthog.…
3
51
1
756
actualizado 1 de julio de 2022

Descripción

PDF

I needed a way to mount a Virpil WarBRD base to my Obutto R3volution which has stick mounts for Thrustmaster Warthog.

So I whipped this adapter plate up. You will need some hardware, Three M4x0.7 Hex Head bolts and nuts to attach the adapter plate to the Warthog mount. The hardware for mounting the plate to the Virpil base is just the M4 screws you should already have that came with the WarBRD to mount the base plate.

You should not need any supports. Once printed, clean out the holes if any cruft got in there.

  1. Place the three bolts through the adapter plate where the hex head recesses are. The bolts should sit countersunk and be flush with the face of the adapter plate.
  2. Attach the adapter plate to your Thrustmaster mount by feeding the bolts through the mount and then securing with the nuts. Hand tighten then give a TEENY amount of wrench pressure if you want but be gentle or you will crush the plastic
  3. Remove the Virpil WarBRD base plate if you have it attached
  4. Using three of the M4 screws that are used to attach the base plate, attach the adapter to the base. Again screw down and tighten carefully so as to not crush the plastic.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Notes:

Infil is up to you. I printed various tests during development using only 5% Gyroid infil and they worked fine. For my final working part I printed with 25% Gyroid infil just to give me some extra strength so I could make sure the bolts were tight.

You should not need any supports, or rafts for this print.

Category: Video Games

Etiquetas



Origen del modelo

El autor ha marcado este modelo como su creación original. Importado de Thingiverse.

Licencia


Modelos destacados del creador

Ver más