Valorant Velocity Karambit

A printable model of the Velocity Battlepass Karambit from Valorant
297
1206
5
7950
actualizado 4 de febrero de 2023

Descripción

PDF

This project is a remix of the Valorant Velocity Karambit by MaitreLancelot on Thingiverse (https://www.thingiverse.com/thing:5198504)

 

This project was created under Riot Games' "Legal Jibber Jabber" policy using assets owned by Riot Games.  Riot Games does not endorse or sponsor this project.

 

I splitted the original model into multiple parts and added clearance for better printability. I also fixed some issues and added screw holes.

 

The model is scaled to real life size (250% compared to the original file, ~25cm end-to-end, it might be a little too big xD).

 

Additional Parts Needed:

1x M3x14mm Screw and Nut

1x M2.5x14mmcrew and Nut

(Note: I used 12mm screws in both cases, but they ended up a bit short, so i'd recommend using 14mm screws)

 

Printing:

Print one of each file.

I printed all parts using PLA with 0.15mm layer height and 15% infill.

 

blade.3mf:

Prints with no supports.

Grip.3mf:

Needs supports on bed.

Lower Button.3mf:

Prints with no supports.

Upper Button.3mf:

Prints with no supports.

 

 

Assemby:

  1. Glue both sides of the blade together.
  2. Glue both sides of the grip together.
  3. Insert the blade into the grip.
  4. Screw blade and grip together using the screws and nuts. The bigger hole is for the M3, the smaller one for the M2.5. Both screws go in from the same side (opposite of the hexagonal hole).
  5.  Put the upper button (round hole) onto the M3 Screw and glue it in place (using doublesided tape).
  6. Put the lower button (hex hole) onto the M3 Nut and also glue it in place (using doublesided tape).

 

 

 

 

Etiquetas



Origen del modelo

El autor ha hecho un remix de este modelo.

Licencia