Axial SCX6 - Receiver Box Replacement

This receiver cap replaces the stock “engine” cap with a simpler design to allow for better air flow and access to the ESC. With this initial release the stock ESC is still needed though a clip for no ESC (in the stock location) is on the way. 

This fits both the stock receiver box and the Vitavon aluminum mount (as pictured). 

To complete you'll need: 

2 x M3x10mm (12mm is ok too) for the cap retainer 
2 x M3 nuts (locknut optional) for the cap retainer
1 x M3x20mm (or so) to allow the cap to screw into the stock location 

The stock gasket is required and you'll need to take that from the stock receiver cap. You can use a hobby knife to carefully get it out.