Customizable drawer handle

Customizable handle for any drawer.
I'm using it with the handle facing up. This way there is almost no chance it will slip up from the drawer door. But you can change it using a parameter to face down.

Used original scad file. Made some adjustments and made it easier for customization.

Attached STL is suitable for IKEA Micke drawer unit with 16.6 mm drawer door thickness.

Print it on a side to reduce support for minimum.

Enjoy

Print Settings

Printer:

Anet A8

Rafts:

Yes

Yes

Resolution:

0.2

Notes:

I set model walls and bottom thickness to 3 mm and wall thickness in the slicer to 1.6 so no infill needed. Adjust it to your customization and slicer wall thickness accordingly and use infill if required.

Print on a side like in attached STL to reduce support.
Support: Touching buildplate - only for rounded corners.
Brim: Yes