A nice cross for the new cardboard filament rolls from RealFilament. It's a tight fit, I made the cross a tad wider than the hole, so a bit of pressure is needed. It let the roll just rotate and not dangling on the alu rod. Print two per roll. You might have to remove the red end cap on the rod to fit the cross.
Printer:
Anycubic i3 mega ultrabase
Rafts:
No
Supports:No
Resolution:
0.2
Infill:30%
Category: 3D Printer AccessoriesThe author marked this model as their own original creation. Imported from Thingiverse.