Heltec v3 case for Meshtastic
Bambu Lab P1S
2
April 11, 2024 at 10:28 AM
Original model
Comments
@M4RCiN_1928869 It looks like the v22 back 11mm is 36.534mm- I had been looking for the correct back too for the makerhawk 3000mah versions.
@M4RCiN_1928869
I have the same battery, I resized the width to 106% and left all other axis to 100% and it worked fine. thats for the whole model.
@TonyG Hi, thank you for your hard work with this model. Would it by possible to make the frame and plates 2,5mm wider? I cant fint the MakerFocus 3000mAh pack. It needs an inner diameter of 36,5mm for a good fit. Thank You :) (edited)