Raspberry Pi 4 Model B case with fan integrated

Raspberry Pi 4 Model B case with fan integrated.

Needed M2,5 screws etc.. see photo for sizes.
A Noctua NF-A4x10 5V fan

You can connect the fan to the 5Volt circuit on the Raspberry Pi or .. as I did to the 3.3V circuit on the Raspberry Pi, that is sufficient. Even with 100% CPU load temp do not arise beyond 50 degrees. No cool element needed in this setup.

Space with between fan and CPU is 3 mm. With the higher top it is 7mm.

Please like or leave a make picture as thank you.

Print instructions

Easy print, used the standard Prusament PETG settings in the Prusa slicer.

DO NOT use PLA!! If the Raspberry get hot... PLA will meld! PLA is a bad idea.