Hasselblad 500 EL/M Battery Door Lock-Screw with Handle

This is a custom made handle/battery-door lock for the Hasselblad 500 EL/M, which does not require a coin or screwdriver to open.

Print instructions

Printed the parts using PLA with a layer height of 0.2mm.
The holes in this design are the tricky part, you'll most likely have to redrill them after printing. If you can't print it with the hole in the smaller cylinder, use the provided _nohole version.
For assembly simply put a 2mm rod through the handle and the main part, this rod will act as hinge for the handle.

Remove the small 2mm rod from your old Hasselblad battery-door-screw and you should be able to remove the screw from the battery-door. Then just insert the new screw and put the rod back in place.

If you enjoyed this print, please give it a like and feel free to buy me a coffee using the Donate-button next to my username on the top of the page. ;-)