Elongated Snap on MK3/MK3S Camera mount for the Logitech C920 Webcam

A long, clip-on camera mount for wide format webcams.
56
453
11
3070
updated February 23, 2023

Description

PDF

I enjoyed this mount but wanted the camera a little further from the print bed. I elongated the arm by 60mm and then also lengthened the mount point so it can accommodate a thumb screw such as this

After using this for a while I found that it was still not far enough for larger prints. Given that I use Octolapse, the Y axis doesn't need the full horizontal view of a 16:9 camera (like my C920). I decided to alter the mount a second time to give a portrait mount point for the camera. To allow this to print without supports I had to then move the camera cable clips to the opposite face. The downside is that it makes the wire more visible.

I don't see why this wouldn't work for any light weight webcam that mounts with a 1/4" screw. The clips were designed by jsund to accommodate a 3mm cable. I've only tested it with a Logitech C920.

Tags



Model origin

The author remixed this model. Imported from Thingiverse.

License