Sunglasses Car Sun Visor Clip V2

Introducing my latest 3D model: a clip that attaches your sunglasses to your car's sunvisor, keeping them within easy reach. This easy-to-print accessory is designed for quick assembly and installation, adding a touch of convenience to your driving experience. Never lose track of your sunglasses again! 😎🚗✨

Thingiverse

This is a design I transferred over from Thingiverse. 

Overview

An updated version of my original sunglasses car clip. 

This version is designed to hold some glasses better, as well as being designed to be less prone to bending because of heat like the previous version was. 

Print Recommendations

For hot climates, PLA will likely melt a bit and cause the model to bend. I would highly recommend printing this model in ASA, this Polymaker ASA works well for me¹. I also would recommend using a higher percentage infill so that there is more plastic if it does soften.

• Layer Height: 0.15-0.2mm Quality
• Material: ASA¹
• Infill: 30% or higher
• Supports: None

V1

Also included is a link to V1 in case you prefer that design or want to read the tips in the comments. Printables Link to V1 or Thingiverse Link to V1

Category: Organization

1) This post contains affiliate links, any link marked with ¹ is an affiliate link. Using these links helps support my work!