Motorola Pulse Escape spare part

Replacement part for the motorola pulse escape headphone. This spare part is supossed to be stronger than the original but it is still going through testing. You manually have to make a hole at the place where the bolt which holds the original parts and the 3D printet one together has to go through. The project is not quite finished yet and there are a lot of things which could be improved (to strong, design,..). So if you want to you can remix the project! I hope the projects helped you to fix your headphones. Also, it would be helpful for me if you write all the issuees you had with this spare part in the comments.

Version 1.2 (Cura Error fixed and little design improvements)

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

0,4

Infill:

40%

Filament:noname PLA Grey

Notes:

Try out different settings for me 40% infill and PLA worked fine (but there might be better settings). Make sure to use a brim or just be brave enough to leave it out.

my printing setup