After realizing that my modifications to my Ender 3 Pro PSU had made it not work with most of the existing Lack PSU mounts, I decided to create my own from the simplest design I could find. This seemed to be the ticket, so I hope some other folks might find it useful as well.
I did have to bust open a whole in the lower half of the PSU frame I printed in order to route the cables since the PSU is flush to the bottom of the Lack table, but then it was easy enough to make work.
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
25
Notes:
Only need supports on the plug end bracket, others can be printed without if they are laid down on the print bed.
Category: 3D Printer AccessoriesThe author marked this model as their own original creation. Imported from Thingiverse.