Remixed this label printer stand to hold the LARGE label rolls I bought off Amazon. Intended for a Munbyn 4x6 label printer, but should work with Rollo and other brands. Added diagonal support to the corners, a lip around the back and sides, and split the roller into two pieces that combine with a peg and some super glue.
DEFINITELY USE A BRIM!!! The corners will almost certainly lift on this 18hr print.
Draft (.3mm) settings in PrusaSlicer, printed on a MK3 with PLA. Make sure to print two of the roller halves and one peg.
Add some rubber feet to the bottom to prevent sliding.
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
No
Resolution:
.3mm
Infill:
15
Filament: Inland PLA
Category: OfficeThe author marked this model as their own original creation. Imported from Thingiverse.