Kobra Max Phone Mount

I was looking for a mount to attach to the front of the Anycubix Kobra Max printer to hold a trakphone with Octa4a but couldn't find any so I made this one up. I used 3 parts from https://www.thingiverse.com/thing:3543845/files, https://www.thingiverse.com/download:8942199, https://cdn.thingiverse.com/assets/ac/67/2d/38/c9/Phone_clamp_down.stl, https://cdn.thingiverse.com/assets/79/1c/b3/21/97/Phone_clamp_up.stl. I have also included a simple side mount that can attach to the left side of the bed with Tnuts.

Print Settings

Printer:

Anycubic Kobra Max

Rafts:

No

Supports:

Yes

Infill:

50%

Notes:

When printing the Kobra Camera Mount lay the model on the long bottom end so that only the supports are in the notch where it goes over the frame, this will use as little as filament as needed.

Post-Printing

Simple Side Mount