Ender-2 XY & XYE TL Smoother bracket

A quick bracket intended to fit two to three TL Smoother boards inside an Ender-2 control box.
1
5
0
135
updated October 13, 2022

Description

PDF

Update 20200122: I've managed to make a design which can fit three (3) TL Smoothers into the factory Ender-2 electronic enclosure. It's an extremely tight fit, however, so make sure the wires are bent clear and be careful when re-installing the cover. Seriously, there's not even 0.5mm between the bottom of the plate and the enclosure.

A quick bracket designed to fit within the main control box to mount two (2) TL Smoothers, intended for use on the X and Y axes. It has been revised slightly since the pictures were taken but is still functionally identical.

Note that this may not fit all TL Smoothers, and likely won't work well with those having right-angle connectors due to space restrictions.

Update 20200717

Added a revised XY bracket. This should print quicker and more reliably, and provide a better fit for the smoothers. I've left the old XY STL in place in case anyone prefers the old design.

 

Requires no supports or special bed adhesion. Be aware that it is a fairly broad print so it may be susceptible to uneven bed heat (if used) or a warped bed.

All vertical measurements were done to fit a 0.2mm layer height, but smaller heights should work without issue.

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License


Highlighted models from creator

View more