Tronxy X5SA Pro Z Axis Spacer

This spacer was created to be printed without supports. This is meant to be put in the two holes near the Z axis thread rod. The spacer goes around the bearing at the top of the axis making it flush with the frame.

When making your Z axis even, be sure to remove the spacers before homing the Z.

I use Klipper and homing the Z moves the bed down before homing the X and Y. This is when I remove them. If you do not remove them, they will hit when the Z is homed.

Print Settings

Supports:

No

Filament:

Matte Green

Notes:

Print with the alignment rods facing up.