Peeping Owl 5015 fan mount bracket for Biqu H2 Extruder

B.OM. :

2 QTY heat melt inserts M3 x 5mm OD x 4mm Length (as used on voron builds)

3 QTY M3 x 8mm socket head cap screws

2 QTY M3 x 25mm socket head cap screws

2 QTY 12mm OD googly eyes

----------

The bracket uses 2 M3 screws secured in slots so you will need to adjust the height of the fan duct before using.   I did this because there are several versions of the h2 with different heat blocks and I couldn't find a bracket that worked with my v2 heat block.

This is my process for dialing in the height:

1. Secure the bracket screws just enough to prevent bracket from drooping, then slide the bracket to its highest position.   

     2. Install fan and duct on bracket

     3. Move the extruder nozzle tip to the bed and align fan duct by sliding it down gently

     4. After dialing in the height, gently remove the fan and duct, trying not to move the     bracket.

     5. Fully Tighten the bracket screws then reinstall fan and duct!

---------

The fan duct itself is not my design, all credit goes to HangTight on thingiverse… I am including it in this package for convenience and in accordance with his license.  

Thanks.