Waist Level Finder WLF Mamiya 645 Pro super

I was blown away by the cost of an OEM Waist Level Finder for my Mamiya 645 Super. I don't use one often but when you want one you want one. So I came up with this. I will probably replace the front tabs with 1mm stainless once they break off. I didn't round any of the edges just so it prints easier. May update later. Lens is from a Old Kodak Slide projector 37mm. Pins are 1/16" stainless - a Jumbo paper clip straighten may also work.

Print Settings

Printer Brand:

Prusa

Printer:

Prusa Clone

Rafts:

No

Supports:

Yes

Resolution:

.15

Infill:

20

Filament: eSun PLA+

Notes:

Print the base flat with support to baseplate only - be careful of tabs when removing support. speed 40 on base 60 on everything else. 20% infill