Hario V60 Filter Holder

My wife was upset about V60 filter holders available in market so she asked me for one.

Since she thinks it is more practical to take filters from top rather than pulling it, it came out in Aeropress style filter holder.

It can hold about 120% of filter pack (50mm internal height) so you don't need to wait to very end to refill. Internal edges are 132mm long so there is slight gap between filter and wall.

I printed it from black PLA on DeltiX printer but any printer shall do its job without problems.

Print Settings

Printer:

Trilab DeltiX

Rafts: 

No

Supports:

No

Resolution: 

0.2mm

Infill:

15% Gyroid, doesn't really matter

Filament: Fillamentum Extrafill PLA Black 
 

Notes: 

Top Layers: 4
Bottom Layers: 3

Nozzle: 0.4 mm (0.6 mm will do as well, walls are 1.2mm thick)

Perimeters: 3

Category: Kitchen & Dining

This is imported from my Thingiverse accout, original entry: https://www.thingiverse.com/thing:3401429