Under desk drawer, 7"x7"

A small 7"x7" drawer to go under your desk, 1.5" deep. To assemble, bend the runners apart slightly to fit the…
10
122
1
526
updated December 23, 2021

Description

PDF

A small 7"x7" drawer to go under your desk, 1.5" deep.

To assemble, bend the runners apart slightly to fit the trapezoid shaped stoppers on the drawer into the groove and hold together while you insert the four screws. I used masking tape to hold everything in place while I installed it.

If you've got everything together correctly after installation the drawer should slide smoothly out and stop itself from completely sliding out.

Print Settings

Printer Brand:

Anycubic

Printer:

All-metal Mega

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

25%


Filament:
TECBEARS PLA Grey

Notes:

The model has the internal dimensions of the drawer at 7x7x1.5 inches, my print bed wasn't quite large enough at 210x210x205 millimeters to fit the whole thing so I had to scale both parts down to 90%, no big deal.

As this part does have a large footprint I experienced some trouble with warping. The warp resulted in a small lip on the front of the print as seen in the pictures, it still functions just fine.

For the runners I waited until the circular screw holes had been finished and used masking tape to hold the four corners down while it continued with the rest of the print. For the drawer itself I used a gluestick on the bed before printing.

Category: Organization

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License


Highlighted models from creator

View more