Testfile for reproducing bad travel paths in Prusaslicer
0
11
0
131
aktualisiert 1. September 2024

Beschreibung

PDF

Test-Model for

https://forum.prusa3d.com/forum/prusaslicer/problem-with-unoptimized-travel-paths/

 

Hi there,

I have a problem with PrusaSlicer. 

I have a multi color print with lots of little colored rectangles surrounding a plain octagon-shaped donut:

After slicing, the travel paths are all over the place:

Instead of printing the red rectangles in clockwise (or counterclockwise) order, they are printed from top to bottom, crossing the empty space in the middle after each rectangle:

Simplification:

Not only do all these travel moves add to the print time, they also increase the amount of possible stringing.

I would like to print the red rectangles in a more optimized way, ideally clockwise like this:

 


 

Herkunft des Modells

Der Autor hat dieses Modell als seine eigene Kreation gekennzeichnet.

Lizenz