rfid box for rc522 and arduino nano

A box to contain an arduino nano connected with a rc522 rfid module.

Not Fully satisfy by Dgoma box design (http://www.thingiverse.com/thing:1413827) I decide to make my own.
Like Dgoma I could only recommend the Miguelbalboa's work for the arduino programmation (GitHub: https://github.com/miguelbalboa/rfid)

There is still improvement to be done (mainly on external aspect) but it's full-fill its function to hold everything in place without screw or glue.

I took dimensions from the only rc522 module I owned. So, it may requires some adjustments/trimming of the box or the rc522 depending of your module (Chineese pcb aren't perfectly identical), or your 3D printers calibrations.

Print instructions

Category: Electronics Summary

A box to contain an arduino nano connected with a rc522 rfid module.

Not Fully satisfy by Dgoma box design (http://www.thingiverse.com/thing:1413827) I decide to make my own.
Like Dgoma I could only recommend the Miguelbalboa's work for the arduino programmation (GitHub: https://github.com/miguelbalboa/rfid)

There is still improvement to be done (mainly on external aspect) but it's full-fill its function to hold everything in place without screw or glue.

I took dimensions from the only rc522 module I owned. So, it may requires some adjustments/trimming of the box or the rc522 depending of your module (Chineese pcb aren't perfectly identical), or your 3D printers calibrations.

Print Settings

Printer:

Prusa i3 China Derivated

Rafts:

Doesn't Matter

No

Resolution:

0.25

20%

Filament: unknown PLA White

Notes:

Printed from a PLA roll I need to finish (never succed to obtain a good aspect with it)