This is a clothes hook that can be screwed to the back of a door with a basic wood screw. It has a countersunk screw hole for this purpose, which is slightly angled for better force transfer.
The edges of the hook are also filleted to prevent the edges of the print from inadvertently scratching you when you go to throw your jumper over it.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.28
Infill:
25%
Filament: Any PLA White
Notes:
I would recommend at least a 1.2mm wall thickness to ensure strength under tensile load. Using a 0.4mm nozzle, that would be 3-4 perimeters. 25% infill seems to be the sweet spot, but you could probably stand to go lower, providing you have enough perimeters.
If you want super-smooth surfaces, enable ironing in your slicer for the top layer, but that's optional. Category: OrganizationDer Autor hat dieses Modell als seine eigene Kreation gekennzeichnet. Importiertes Modell von Thingiverse.