Ikea Akerbar Greenhouse Window Ledge Supports

Supports for the Ikea Akerbar Greenhouse to allow them to sit on a window ledge
15
25
0
1416
aktualizováno 19. března 2023

Popis

PDF

We wanted to keep our Ikea Akerbar sitting on the window ledge, but the greenhouse was too deep to sit there safely. I designed these to be installed on our window trim to support to avoid any accidents.

I designed this with easy screwdriver access in mind. No supports required. Print with the hypotenuse side on the build plate.

Could also be utilized for supporting shelving etc.

Dimensions: D 3" H 2.25"

MY PRINT SETTINGS:

PrinterPrint TimeLayer HeightNozzleMaterialFilamentInfill
Bambu Lab P1P36m45s0.24mm0.4PLA16.37g15%

Note: I used 4 wall loops for the added strength.

Štítky



Původ modelu

Uživatel se označil za původního autora tohoto modelu.

Licence