18650 battery holder and landingfeet
Přihlášen do soutěže Do oblak!
6
33
0
444
aktualizováno 1. února 2023

Popis

PDF

18650 battery holder

I am using a DYI 18650 (LG HG2) with spot welded nickel strips and soldered XT30 lead.
The battery strap is an iFlight 10mm strap shortened by about 10mm.
Supports are required if printing in default orientation.
Printed in TPU.

Landing feet

I modified the bottom plate of the frame to acommodate a whoop 1s FC with a bottom facing USB. These feet raise the quad 10mm from the ground. They also fasten with only two 6mm M2 screws (I am using nylon).
I printed a set of 5 at a time, laying them flat on the mounting face, no supports required.
Printed in TPU.

Štítky



Původ modelu

Uživatel se označil za původního autora tohoto modelu. Importováno z Thingiverse.

Licence